Using the Surround Processor

Preparing for Surround Modes

Once you have set the surround modes, you can use the same adjustments every time you want to activate the surround mode you want. The receiver memorizes surround adjustments for each mode.

On the front panel:

1. Press SURROUND so that the Control %/ Þ/ @ / #

SURROUND

 

buttons work for selecting the Surround Processor

 

mode.

 

The lamp above the button lights up.

2. Press Control % / Þ to select one of the surround mode (“PROLOGIC,” “3CHLOGIC” or “THEATER”).

Each time you press the button, the Surround Processor modes change as follows:

Ex. PROLOGIC THEATER 3CHLOGIC

OFF 3DACTION* PAVILION*

PROLOGIC

Select this mode when you use a center speaker and rear

 

speakers.

THEATER

Select this mode to watch a video source with Dolby Surround

 

when you have connected the rear speakers (and a center

 

speaker). This mode gives you the feeling of a movie theater.

 

 

3CHLOGIC

Select this mode when you use a center speaker without rear

 

speakers.

OFF

Select this to turn off the Surround Processor mode.

 

 

*You cannot select the 3D-PHONIC modes or the DAP modes in this step. For the 3D-PHONIC modes: see pages 27 and 28.

For the DAP modes: see pages 29 and 31.

Note:

When one of the surround modes is selected, the corresponding indicator lights up on the display.

3. Press ADJUST so that the Control %/ Þ / @ / # buttons work for adjusting the selected surround mode.

The lamp above the button lights up.

4. Press Control % / Þ until “CNT MODE” (Center Mode) appears on the display.

ADJUST

33

Page 36
Image 36
JVC RX-664VBK Preparing for Surround Modes, Press Surround so that the Control %/ Þ/ @ / #, Prologic, Theater, 3CHLOGIC