FM tuner IHF, AM tuner, General | JVC RX-664VBK specs

FM tuner (IHF)

Tuning Range		87.5 MHz to 108.0 MHz
Usable Sensitivity		10.8 dBf (0.95 µV/75 ohms)
50 dB Quieting Sensitivity	Monaural	16.3 dBf (1.8 µV/75 ohms)
	Stereo	38.3 dBf (22.5 µV/75 ohms)
Signal-to-Noise Ratio (IHF-A weighted)	Monaural	80 dB at 85 dBf
	Stereo	73 dB at 85 dBf
Total Harmonic Distortion	Monaural	0.15 % at 1 kHz
	Stereo	0.2 % at 1 kHz
Stereo Separation at REC OUT		40 dB at 1 kHz
Capture Ratio		1.5 dB (10 mV)
Alternate Channel Selectivity		60 dB: (±400 kHz)
Frequency Response		30 Hz to 15 kHz: (+0.5 dB, –3 dB)
AM tuner
Tuning Range		530 kHz to 1,710 kHz
Usable Sensitivity	Loop antenna	300 µV/m
	External antenna	30 µV
Signal-to-Noise Ratio		50 dB (100 mV/m)
General
Power Requirements		AC 120 V , 60 Hz
Power Consumption		330 watts/440 VA
		5 watts (in standby mode)
Dimensions (W x H x D)		17 3/16 x 5 3/4 x 15 7/8 inches
		(435 x 146 x 403 mm)
Mass		20.7 lbs (9.4 kg)

Design & specifications are subject to change without notice.

Page 53

Image 53

JVC RX-664VBK manual FM tuner IHF, AM tuner, General

Contents

RX-664VBK To Reduce the Risk of Electric Shock Center Speaker Level Rear Speaker Level Effect Level For actual setting procedures, see pages 26 to Table of Contents Front Panel Remote ControlParts Identification For Reproducing Surround Sound with your VCR Easy Set Up & Operations Turn on the power For Reproducing DVD Multi Playback with your DVD player Easy Set Up & Operations Audio Sound VCR Control Disc General Getting StartedLocations Handling the receiver AM Antenna Connections Connecting the FM and AM AntennasFM Antenna Connections Connecting the Speakers Connecting the front speakersGetting Started Connect the front speakers to the Front Speakers terminals Connecting the subwoofer Connecting the rear and center speakers Audio component connections Connecting Audio/Video ComponentsVideo component connections If your audio components have a Compu LINK-3 terminal If your audio components have an AV Compu Link terminal DVD player connection Putting Batteries in the Remote Control Connecting the Power Cord Turning the Power On and Off From the remote controlBasic Operations On the front panel On the front panel only From the remote control onlyBasic Operations Recording a Source Listening with HeadphonesTo listen with only headphones Adjusting the Front Speaker Output Balance Basic SettingsListening at Low Volume Loudness Using the Sleep Timer To cancel the Sleep Timer When the shut-off time comesReceiver turns off automatically Press Sleep repeatedly Selecting the Center Speaker Size Basic SettingsSmall Large To recall the sound settings To store the sound settingsTo cancel the One Touch Operation function One Touch Operation Using Preset Tuning Tuning in Stations ManuallyTo store the preset stations Receiving Radio Broadcasts Press 10 keys to select a preset channel number To cancel a stored preset stationTo tune in a preset station Receiving Radio Broadcasts Selecting the FM Reception Mode To cancel the preset SEA mode Using the Preset SEA ModesSelecting Your Favorite SEA Mode Press SEA Preset to select the effect level Using the Preset SEA Modes On JVC 3D-PHONIC mode Using the Surround ProcessorOn the DAP mode On surround modes Using JVC 3D-PHONIC Modes Using the Surround Processor3DACTION 3DTHEATR To cancel the 3D-PHONIC mode Press Control @ / #to adjust the effect levelPress Effect to select the effect level Each time you press the button, the level changes as Hall Using the DAP ModesPavilion Press Rear L +/- to adjust the rear speaker Output level To cancel the DAP modeSelect OFF in step DAP indicator goes off from the display Effect Select 3CHLOGIC Select Normal or Wide for center mode Select Prologic or Theater Select Phantom for center modeSpeaker Arrangements for Surround Modes This case Press Surround so that the Control %/ Þ/ @ / # Preparing for Surround ModesPrologic Theater Delay Press Control @/ # to select the center modeWide Normal Each time you press the button, the effect level changes If necessary, adjust the speaker output balance as follows Press Test again to stop the test tone Press Effect to adjust the effect levelPress Test to start checking the speaker output balance To cancel Surround mode Using Surround ModesPrevious mode is recalled with its previous From the front panel Activating the DVD Multi playback Using the DVD Multi Playback ModeSpeaker arrangements for DVD Multi playback Using the DVD Multi Playback Mode Remote Control through the Remote Sensor on the Receiver Compu Link Remote Control SystemAutomatic Source Selection Synchronized Recording Components with RCA pin plugs AV Compu Link Remote Control System Automatic Power On/Off Automatic Selection of TV’s Input ModeSee page 44 for details One-Touch Video Play Operating Other Components To operate JVC audio components using this remote controlStarts playing Starts playback Following operations on the TV To operate JVC video components using this remote controlAfter pressing TV SOUND, you can perform Return TV Volume +TV/VIDEO Selects the channel Section Converter or satellite tunerEquipment requires pressing Enter Alternates between previously Operating Other Manufacturers’ Video Equipment Release VCR in the Power sectionTry to operate your VCR by pressing VCR Power Problem Possible Cause Solution Troubleshooting Amplifier Specifications General FM tuner IHFAM tuner HOW to Locate Your JVC Service Center Limited Warranty AUDIO-2 1297OFMMDWJEM