
When playing a software encoded with the DTS Digital
Surround, “AUTO” may not work properly and the following symptoms may occur:
•Sound does not come out at the beginning of playback.
•Noise comes out while using the searching or skipping function.
In this case, press CONTROL UP 5/ | DOWN UP |
| CONTROL |
DOWN °to select “DTS” while “AUTO” |
|
is lit on the display.
•Each time you press the button, the input mode changes as follows:
AUTO 
DTS
(Digital) (Digital)
Note:
When you turn off the power or select another source, “DTS” setting is canceled and the digital input mode is automatically reset to “AUTO.”
To change the input mode back to analog input, select
“ANALOG” by pressing INPUT ANALOG/DIGITAL again.
From the remote control:
1. Press the source selecting | DVD | DVD MUILTI | CD | FM/AM |
button (DVD, CD, TV/ | TV/DBS | VCR | TAPE/CDR | PHONO |
DBS, or TAPE/CDR)* for |
|
|
|
|
which you want to change |
|
|
|
|
the input mode. |
|
|
|
|
Note:
*Among the sources listed above, you can select the digital input only for the sources which you have selected the digital input terminals for. (See “Digital Input (DIGITAL IN) Terminal Setting.”)
2. Press ANALOG/DIGITAL to | ANALOG/DIGITAL |
| |
change the input mode. | INPUT |
|
•Each time you press the button, the input mode changes as follows:
ANALOG 
AUTO
(Digital)
When playing a software encoded with the DTS Digital
Surround, “AUTO” may not work properly, In this case, press CONTROL UP 5/DOWN °on the front panel to select “DTS.” (See above.)
Note:
You can only select “ANALOG” and “AUTO” using the remote control.
Storing the Basic Settings and
Adjustments
You can assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
The following can be stored for each source:
•Bass boost (see page 12)
•Tone adjustment (see page 12)
•Input attenuator mode (see page 12)
•Subwoofer output level (see page 12)
•Balance (see page 13)
•DSP modes
–Surround mode (see page 23)
–DAP mode (see page 25)
•DVD MULTI playback mode (see page 27)
The above settings are stored automatically in the following cases:
•When you turn on the power.
•When you change the source.
•When you assign the source name.
Notes:
•You cannot assign and store different settings for digital input mode and analog input mode.
•The DSP modes and DVD MULTI playback mode cannot be used at the same time.
•If the source is FM or AM, you can assign a different setting for each band.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly. | SLEEP |
|
The SLEEP indicator lights up on the display, and the
10
20
30
40
50
60
70
80
90
00(Canceled)
When the
The receiver turns off automatically.
To check or change the time remaining until the
Press SLEEP once.
The remaining time until the
• To change the
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00 MIN.” appears on the display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
17