

Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier.
Recording a Source
For analog-to-analog recording
You can record any analog source through the receiver to —
•the cassette deck (or CD recorder) connected to the TAPE/CDR jacks, and
•the VCR connected to the VCR jacks
— at the same time.
Changing the Source Name
When you have connected a CD recorder to the TAPE/CDR jacks or the DBS tuner to the TV SOUND/DBS jacks on the rear panel, change the source name which will be shown on the display when you select the CD recorder or DBS tuner as the source.
On the front panel ONLY:
For digital-to-digital recording
You can record the currently selected digital input through the receiver to a digital recording device connected to the DIGITAL OUT terminal.
Notes:
•
•The output volume level, bass boost (see page 12), tone adjustment (see page 12), and DSP modes (see page 20) cannot affect the recording.
•The test tone signal (see pages 23 and 24) does not come out through the DIGITAL OUT terminal.
When changing the source name from “TAPE” to “CDR”:
• Press and hold TAPE/CDR/ SOURCE NAME to assign “CDR.”
When changing the source name from “TV SOUND” to “DBS”:
• Press and hold TV SOUND/DBS/ SOURCE NAME to assign “DBS.”
Adjusting the Front Speaker Output
Balance
If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance.
Before you start, remember....
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until | ADJUST SETTING |
“L/R BALANCE” appears on the |
|
display. |
|
To change the source name to “TAPE” or “TV SOUND,” repeat
the same procedure above — press and hold TAPE/CDR/SOURCE NAME to select “TAPE” or TV SOUND/DBS/SOURCE NAME to select “TV SOUND.”
Note:
Without changing the source name, you can still use the connected components. However, there may be some inconvenience.
–“TAPE” or “TV SOUND” will appear on the display when you select the CD recorder or DBS tuner.
–You cannot use the digital input (see page 16) for the CD recorder.
–You cannot use the COMPU LINK remote control system (see page 28) to operate the CD recorder.
The display changes to show the current setting.
2.Press CONTROL UP 5/DOWN ° to adjust the balance.
•Pressing CONTROL UP 5 decreases the left channel output from CNTR (Center) to
•Pressing CONTROL DOWN °decreases the right channel output from CNTR (Center) to
CONTROL
DOWN UP
13