FM/AM tuner operations

FM/AM tuner operations are mainly done from the remote control.

NOTE

When you have selected “FM” or “AM” by using SOURCE SELECTOR on the front panel, the remote control may not work for tuner operations. To use the remote control for tuner operations, select “FM” or “AM” by using the FM/AM button on the remote control.

Tuning in to stations manually

From the remote control ONLY:

1Press FM/AM to select the band.

The last received station of the selected band is tuned in.

•Each time you press the button, the band alternates between “FM” and “AM.”

2Press repeatedly or hold TUNING 9 or ( TUNING until the station you want is tuned in.

•Pressing (or holding) TUNING 9 increases the frequency.

•Pressing (or holding) ( TUNING decreases the frequency.

NOTES

•When you hold and release TUNING 9 or ( TUNING, the frequency keeps changing until a station is tuned in.

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

•When an FM stereo program is received, the STEREO indicator also lights up.

Using preset tuning

Once a channel number is assigned to a station, the station can be quickly tuned in by selecting the number. You can preset up to 30 FM and 15 AM stations.

7 To store the preset stations

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

From the remote control ONLY:

1Tune in to the station you want to preset (see “Tuning in to stations manually” above).

•If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM reception mode” on page 25.

2Press MEMORY.

The channel number position starts flashing on the display for about 5 seconds.

24