JVC SP-PWV70 Using the remote control for TV operations, Press and hold TV, Press TV CONTROL

Using the remote control for TV operations

You can operate your TV using the remote control supplied with this system.

• Refer also to the instruction manuals supplied with your TV.

		TV	AUDIO	TV
AUX	FM/AM	DVD	VCRVCR1	button
AUDIO	ANGLE	SUBTITLE	DECODE
RETURN	DIGEST	ZOOM	VFP
		+
TOP MENU	MENU	ZOOM	PROGRESSIVE

–SOUND

CONTROL	– SUBWOOFER +			EFFECT
VCR	1		2	3
	–	CENTER	+	TEST
TV	4		5	6	Number
SLEEP	–	REAR-L	+
	7		8	9	buttons
SETTING	–	REAR-R	+
	10		0	+10	TV CONTROL
	TV RETURN FM MODE			100+
ON					button
SCREEN				AUDIO/
				TV/VCR
				CATV/DBS	Remote
		ENTER
				SURROUND	control mode
CHOICE				MODE
					selector
TV VOL	CHANNEL		VOLUME		CHANNEL
					+/– buttons
	TV/VIDEO MUTING				TV/VIDEO
1				¡
/REW		PLAY		FF/	button
DOWN		TUNING		UP

7Setting the remote control signal for operating your TV.

•You can operate your TV without setting the remote control signal if your TV is a

JVC TV.

1Slide the remote control mode selector to ”AUDIO/TV/VCR.”

2Press and hold TV .

• Keep it pressed until step 4 is finished.

3Press TV CONTROL.

4Press Number buttons (1-9, 0) to enter a manufacturer’s code (2 digit).

See the list below to find the codes.

•For a Hitachi TV, press 1, then 0.

•For a Toshiba TV, press 0, then 8.

5Release TV .

6Try to operate your TV by pressing TV .

When your TV turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of TV, try each one until you enter the correct one.

REC STOP	PAUSE	TV VOL +/–
MEMORY	STROBE
DIMMER		buttons

RM–STHV70U

DVD CINEMA SYSTEM

Manufacturers’ codes* for TV

Manufacturer	Code	Manufacturer	Code
JVC	01	Samsung	12
Hitachi	10	Sanyo	13
Magnavox	02	Sharp	06
Mitsubishi	03	Sony	07
Panasonic	04,11	Toshiba	08
RCA	05	Zenith	09

*Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

7To operate your TV

You can use the following buttons for operating your TV:

IMPORTANT:

When using the remote control, check to see if its	AUDIO/
remote control mode selector is set to the correct	TV/VCR
	CATV/DBS
position:

To operate TV, set it to “AUDIO/TV/VCR.”

TV : Turns on and off your TV.

TV VOL +/–: Adjust the volume.

TV/VIDEO: Select the input mode (either TV or VIDEO).

•After pressing TV CONTROL, you can perform the following operations on the TV.

CHANNEL +/–: Changes the channels.

1-10, 0, +10 (100+): Selects the channel.

20