JVC SP-XSV70, SP-PWV70 manual Troubleshooting, DVD Playback

Troubleshooting

General

PROBLEM	POSSIBLE CAUSE	SOLUTION
Sound from one front speaker	The speaker cord is not connected	Connect the cord correctly.
only.	correctly.	(See page 13.)
	Left-right balance is not set properly.	Adjust the balance properly.
		(See pages 59 and 66.)
No sound from the center and/or	The speaker setting is incorrect.	Set the speaker setting properly.
		(See pages 60 and 66.)
rear speakers.
The system does not work	Lightning or electronic noise interferes	Switch the power off, and remove and re-
correctly.	with operation of the microcomputer.	insert the power plug in the socket.
	Immediately after beginning to heat the	Switch the power off and leave the unit a
	room, the system was moved to a cold	few hours before switching the power on
	location causing condensation to form	again.
	inside.

DVD Playback

No picture is displayed on the TV	The video cord is not connected	Connect the cord correctly.
screen.	correctly.	(See page 10.)
	TV input selection is incorrect.	Select the correct input on the TV.
	The disc is not playable.	Use a playable disc. (See page 6.)
No picture is displayed on the TV	The scan mode is set to “PROGRESSIVE”	Change the scan mode to “INTERLACE.”
screen, the picture is blurred, or	though the system is connected to the TV	(See page 26.)
the picture is divided into two	which does not support the progressive
parts.	video input such as a conventional TV.
A disc cannot be played.	The system’s and disc’s Region Code	Replace the disc. (See page 6.)
	numbers are incompatible.
	Parental Lock is in use.	Enter password to change the parental
		level. (See page 64.)
A disc cannot be played and	The disc is inserted with its label and	Insert the disc correctly.
“0:00” is displayed on the display	data sides inverted.	(See page 27.)
window.
	The unplayable disc is inserted.	Replace the disc. (See page 6.)
Video and audio are distorted.	The disc is scratched or dirty.	Replace or clean the disc.
		(See page 71.)
	A VCR is connected between the center	Connect the center unit and TV directly.
	unit and the TV.
	With some discs, a picture may be	Set “PROGRESSIVE MODE” to “VIDEO.”
	blurred when setting “PROGRESSIVE	(See page 58.)
	MODE” to “FILM” or “AUTO.”
The picture does not fit the TV	“MONITOR TYPE” is not set correctly.	Set the monitor type correctly.
screen.		(See page 58.)
	The TV is not set correctly.	Set the TV correctly.
No subtitle appears on the TV		Some DVDs are programmed to always
screen though you have selected		display no subtitle initially. If this
as your initial subtitle language.		happens, press SUBTITLE on the remote
		control after starting play. (See page 41.)
Audio language is different from		Some DVDs are programmed to always
the one you have selected as		use the original language initially. If this
your initial audio language.		happens, press AUDIO on the remote
		control after starting play. (See page 42.)

73