EDITING EN 63
|
| Edit From A Camcorder |
| Slide the TV/CABLE/DBS/DVD switch to DVD. | |
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 1 Make connections. | |
You can use a camcorder as the source player and your unit as the | |||||
| A If the camcorder has no | ||||
recording deck. |
| ||||
| — connect the camcorder’s AUDIO/VIDEO OUT connectors to the | ||||
|
|
|
|
A If the camcorder has no | unit’s [AUDIO] and [VIDEO] input connectors on the front panel. | ||
|
| ● When using a monaural camcorder, connect its AUDIO OUT | |
|
| connector to the [AUDIO L] input connector on your unit. | |
|
| B If the camcorder has an | |
|
| only) | |
|
| — connect the camcorder’s AUDIO OUT and | |
|
| connectors to the unit’s [AUDIO] and | |
|
| on the front panel. | |
|
| 2 Press VCR/DVD repeatedly to select the recording deck. | |
| Recorder | 3 Press CH +/– to select | |
| ● Set “FRONT AUX | ||
To | To [AUDIO] input | ||
or | |||
[VIDEO] |
|
input | connector being used. ( pg. 70) This setting is also applied to the | |
VCR deck. | ||
| ||
| 4 For VCR deck only | |
|
Video | Audio cable (supplied) |
cable (not |
|
supplied) |
|
| AUDIO OUT |
VIDEO OUT | Player |
5 Press REC MODE repeatedly to set the recording mode.
6 Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.
7Press 7 on the unit to start recording. Or while holding 7, press
4on the remote control. The dubbing starts.
8Press 8 on the unit, then stop playback on the camcorder.
NOTES:
●All necessary cables can be obtained from your dealer.
●Refer to the camcorder’s instruction manual for operating procedure.
●The quality of dubbed picture becomes poorer than that of the original.
●When you select “EDIT” to dub tapes in step 4, be sure to select “AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes.
To | To [AUDIO] input | Recorder |
input |
|
|
Audio cable (supplied)
AUDIO OUT
(supplied) | Player |