JVC SR-MV55U, SR-MV45U manual Connecting To a Dolby Digital Decoder, Optional coaxial cable

		SYSTEM CONNECTIONS EN 57
	Connecting To A Dolby Digital Decoder	1 Connect the unit and a Dolby Digital decoder or an amplifier
		with built-in DTS using either an optional optical cable or an
	Or An Amplifier With Built-in DTS	optional coaxial cable.
		NOTES:
		● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
These instructions enable you to connect your unit to a Dolby
		DIGITAL/PCM”. ( pg. 58)
Digital decoder or an amplifier with built-in DTS.
		● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
		( pg. 58)
		CAUTIONS:

Dolby Digital Decoder or amplifier with built-in DTS

To DIGITAL AUDIO input

Optical cable (not supplied)

To [DIGITAL AUDIO OUT (OPTICAL)]

Coaxial cable (not supplied)

To [DIGITAL AUDIO OUT (COAXIAL)]

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

Rear of unit

Note for connection:

Remove the protection cap from the cable.