JVC SR-VS10U manual SET DBS Receiver Brand, JVC Dish Network Echostar Dish Network, Jvc

20ENINITIALSETTINGS(cont.)

7

ACCESS DBS RECEIVER BRAND SET SCREEN

Press OK.

SET DBS RECEIVER BRAND

CH 8

Press the appropriate NUMBER keys to enter the DBS Receiver Code from the following list, then press OK.

DBS RECEIVER BRAND SET

4 0

PRESS NUMBER KEY (0–9)

THEN (OK) TO TEST PRESS (MENU) TO END

T W

1 2 3

2

4 5 6

NUMBER

7 8 9

0 4

1 DV VHS

3

BRAND	CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

●After OK is pressed, the program currently received through the DBS receiver will appear for about 10 seconds.

●If the DBS receiver's channel changes to the channel listed below for your brand of DBS receiver, setting is complete. Press OK and "DBS RECEIVER CONTROL IS ON" appears on the screen for about 5 seconds, then it returns to the normal screen.

JVC [ 100

ECHOSTAR [ 100

PRIMESTAR [ 55

SONY [ 205

RCA [205

●If the DBS receiver's channel does not change as shown above, press CH 5° or %Þ to move the highlight bar (arrow) to "NO", then press OK. Re- enter the correct code.

OK

NOTES:

●It is possible that the Controller will not work with all types of DBS receiver.

●If your DBS receiver doesn’t respond to the code, you can’t use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●The VCR can only change the satellite channel through the Controller during timer recording.

●If your DBS receiver is one that can’t be operated with a remote control (because it has no remote sensor), you can’t use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●If you are unable to set the Controller, please contact JVC toll free at 1-800-252-5722.