JVC SR-VS10U manual END Audio Dubbing, When monitoring the sound during Audio Dubbing

LAY

STOP

PAUSE

EN61

START DUBBING

6 Engage the audio component's Play mode, then press PLAY to start the tape in your VCR. Audio dubbing begins at this point.

● blinks and is displayed on the front display panel.

● To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing.

END AUDIO DUBBING

7 Press STOP to stop the tape in your VCR, and engage the audio component's Stop mode.

NOTES:

● When monitoring the sound during Audio Dubbing, the

			normal soundtrack is automatically selected. If you wish to
			hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks),
			refer to the "Select The Soundtrack" section (☞ pg. 29) and
1	T	W	select the soundtrack you wish to hear. (VHS deck only)
	2	3	● Audio dubbing stops automatically when the counter reaches
		2
4	5	6	"0:00:00", and the VCR enters the Play mode. Check the
7	8	9	counter reading before dubbing. (VHS deck only)
			● Audio dubbing is also possible using the rear AUDIO IN
	0	4	connectors.

●Audio dubbing cannot be performed on a VHS/S-VHS

		cassette that has had its record safety tab removed, or on a
		Mini DV cassette that has had its erase protection switch set
		to "SAVE".
1	DV VHS	● When playing back an audio-dubbed tape, refer to the "Select
PLAY		The Soundtrack" section (☞ pg. 29) to select the soundtrack
		you wish to hear.
	PAUSE	● Picture may be distorted during Audio Dubbing Pause.
STOP		● It may be unlawful to record or play back copyrighted
		material without the consent of the copyright owner.
		● Audio dubbing is not possible using the DV IN/OUT
		connector.
	3