JVC TK-C1430 manual 22 Y/C OUT Y/C output connector, Video OUT Video signal output connector

	(				)		⁄
	+	-
	1	2	ISOLATEDPOWER ONLY
DC12V	AC24V	CLASS2 ONLY(U TYPE)		(E TYPE)
				TX+ TX- RX+ RX- AUX GND
				A	B	C	D
fi							Y/C OUT
	SYNC IN	VIDEO OUT
›							SEE INST-
	POWER						RUCTION
							MANUAL
‹

¤

19[DC 12V, AC 24V] Power input terminals To input DC 12V or AC 24V power.

20[TX+A, TX-B, RX+C, RX-D] Control signal connection terminals Terminals for inputting signals with electrical characteristics conforming to the EIA/TIA RS-422A or RS-485 standard.  17 RX.TERM switch

21[AUX, GND] Auxiliary Input/Output

Terminals

If there is any change in the area set on the MOTION DETECT screen, these terminals output the corresponding signals. ( Page 34)

These terminals also output the B&W/ COLOUR signal. ( Page 30) [Open-collector low signal. Maximum voltage 30V, current 30mA.]

When carrying out B&W/COLOUR switching using the control signal, the signals are input through these terminals. ( Page 30)

[B&W: make; COLOUR: break]

22[Y/C OUT] Y/C output connector

This 4-pin connector outputs the luminance and chrominance signal.

• Pin configuration of Y/C OUT connector

43

2 1

Pin No. Signal

1GND

2GND

3Luminance (Y)

4Chrominance (C)

23 [VIDEO OUT] Video signal output connector

This BNC connector outputs a composite video signal. Connect this to the video input connector of a video monitor, switcher, etc.

24[POWER] Power indicator lamp

This lamp lights when power is supplied to the camera.

25[SYNC IN] Sync signal input connector This BNC connector accepts the input of an external sync signal such as a composite video (VBS) or black burst (BB) signal. When a sync signal is input into this connector, the camera operation is automatically synchronized with the external sync signal.

To terminate this connector at 75Ω, turn ON the EXT.TERM switch 14 .

E-11