JVC TK-C1460B instruction manual Procedures, Attached 4 pin plugs

CONNECTION/INSTALLATION

Procedures

Execute connection/installation according to the procedures described below.

Turn OFF the power supply to all equipment to be used before making carefully.

Mounting the lens Mount the lens according to the procedures described below.

4.Setting the switches	6.Back focus adjustment
( Page 13)	( Page 21)

1.

Before mounting a lens, check whether it is a C-mount or CS-mount lens. To change the mounting method, loosen the back-focus locking screw (M 2.6) using a Phillips head screwdriver, turn the back-focus adjusting ring with your fingers or the screwdriver and change

7.Auto white balance control adjustment ( Page 22)

	SET
	CAMERA
	SETUP	EXT TERM-OFF	ON
MENU		INT/GL	LL	ALC	AvPk
		IOT USED	SIMPLEX
		DUPLEX
		RX TERM-OFF	ON
				LEVEL	L H
			VIDEO
			DC

	5.Lens adjustment
	( Page 20)
3.Mounting the camera	1.Mounting the lens
( Page 18)	( Page 15)

(b)F

(c)

the mounting method. Dimension (b) of the lens shown in the illustration must be as shown in the table below. If (b) exceeds the value in the table, it may damage the inside of the camera or correct mounting may be im- possible; never use such lenses. Do not attach the C-mount lens when using a CS-mount.

3.

VIDEO

DC

Lens	Flange back (c)	Dimension (b)
C mount lens	17.526mm	10mm or less
CS mount lens	12.5mm	5.5mm or less

To controlling systems such as RM-P2580

DC 12V/AC 24V power supply

2.

4.

1 3

2.	The F mark indicates a focal point.
	Mount the lens on the camera by turning
	the lens clockwise. Adjust its position.
3.	When using an auto-iris lens with an EE

2.Connections ( Page 16)

DC12V

+	-
1	2
AC24V

ONLY(U TYPE)	POWER ONLY	(E TYPE)
CLASS 2	ISOLATED

TX+

A

TX- RX+

B C

RX-

D

AUX GND

To alarm terminals such as switches

2 4

3

	amplifier, turn the switch to the “VIDEO”
	side. When no EE amplifier is equipped,
	turn the switch to the “DC” side.
4.	If the lens has an auto-iris mechanism,
	connect the lens cable after checking the

Genlock sync	Y/C OUT
signal generator
SYNC IN	VIDEO OUT
	SEE INST-
POWER	RUCTION
	MANUAL

Monitor

1

2

4

pin arrangement.

If the lens cable has a different type of

plug, use the 4-P plug supplied.

This is the connected example of the TK-C1480BE. TK-C1481BEG ( Page 16)

	Attached 4 pin plugs
Lens	DC IRIS		VIDEO IRIS	1	3
Pin No.	(does not contain EE amplifier)		(contain EE amplifier)
1	Brake	–	9V [max 50mA]
2	Brake	+	NC
3	Drive	+	VIDEO
4	Drive	–	GND	2	4

E-14 E-15