Setup

System Example (continued)Precautions when using RM-P2580E:

When operating a system using the RM-P2580E,several cameras (up to

16)can be connected and used on one control signal cable. Consequently, an incorrect switch setting on just a single camera will cause the entire system to work incorrectly.

Confirm switch settings on the monitor screen using the following methods.

1.

2.

Confirm that the image from the camera to be checked is displayed on the monitor.

Turn ON the power of the camera to be checked.

The image is displayed on the monitor screen as shown below. (When MACHINE ID is set to A05B)

PROTOCOL : DUPLEX ID-05

Confirm that ADUPLEXB is displayed

Check whether the ID is correct

3.Confirm that ADUPLEXB is displayed and that the ID number is correct.

Memo:

●The number should be the same as the number of the VIDEO INPUT terminal on the back panel of the RM-P2580Econnecting the camera to be checked.

4.If the number is wrong, set the MACHINE ID again.

Memo:

●When controlling this camera with any system except the RM-P2580E,perform proper settings using switches and menu screens according to the system used.

18