Note:

●If thin cables are used, the resistance of the cables will be high and a significant voltage drop will occur when the camera is at its maximum power consumption. Either use a thick cable with low resistance or place the power supply near to the camera and shorten the length of the cable to restrict the voltage drop at the rated current of camera to below 10 %. If voltage drop occurs during operation, the performance will be unstable.

●Do not connect an AC 24 V cable to a commercial power supply. The camera will be damaged. If the wrong cable is connected, the internal circuit may be damaged. Do not use the camera. Bring it to your nearest JVC dealer for inspection.

TK-C1531EG(AC 220 V-240 V)

Connect the power supply cable to the AC 220 V-240 V power supply.

Note:

●When you use this camera, the socket - outlet must be installed near the equipment to make disconnect on easily.

Video signal coaxial cable

Use either RG-59 or RG-11 coaxial cable (BNC).

Do not use other cables.

Connecting the control signal cables

Connect the control signal cables in a system where RM-P2580Eis used. As shown in the diagram below, connect the cables such that the TX+ A and TX- B signals and the RX+ C and RX- D signals are in pairs.

A TX+

ˇ

Connect in pairs like this.

 

BTX-

C RX+

ˇ

 

Connect in pairs like this.

DRX-

Memo:

●The use of 0.65 mm 4-core (2 pairs) twisted pair cables of impedance 110K is recommended.

The maximum connection distance with RM-P2580Eis 1200 m. For RM-P2580E,several cameras (up to 16) can be connected to one cable but the total extension of the cable must be within 1200 m. This is for the case when the conductor resistance of the cable is below 110K and its impedance is 110K.

23