(Continued) Remote Control
This page is for when operating your TV using the remote control of this product.
Operating the TV Using the Remote Control
Remote control mode selector
Number buttons |
Setting the manufacturer's code
1 Slide the remote control mode selector to the TV side.
2 Hold down .
Hold down until step 4 is completed.
3 | Press | and release. |
|
4 | Press number buttons ( | ). |
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are two or more manufacturer's codes, try them in turn and select the one that enables the product to work properly.
Manufacturer | Code | Manufacturer | Code |
JVC | 01 | Samsung | 12 |
|
|
|
|
Hitachi | 10 | Sanyo | 13 |
|
|
|
|
Magnavox | 02 | Sharp | 06 |
|
|
|
|
Mitsubishi | 03 | Sony | 07 |
|
|
|
|
Panasonic | 04, 11 | Toshiba | 08 |
|
|
|
|
Philips | 14 | Zenith | 09 |
|
|
|
|
RCA | 05 |
|
|
|
|
|
|
5 Release .
NOTE
•The manufacturer's codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above.
For TV operation
Operate the remote control by pointing it towards the TV.
| Turn on/off the power. |
| Change channels. |
| Adjust volume. |
- | / |
| Select channels. |
/ | *1 |
| Change between the previously |
| selected channel and the cur- |
| rent channel. |
| Change between TV and video |
| input. |
*1 Make sure to slide the remote control mode selector to the TV side in advance.
NOTE
•When the batteries are replaced, perform the man- ufacturer's code setting again.
9