English KMR 1550 D 24
1. Operating hours counter
2. Swinging up debris container
3. Dumping debris container
4. Tilting back debris container
5. Swinging back debris container
6. Filter shaker
1. Cooler
2. Alternator
3. Fuel filter
4. Oil filter
5. Starter motor
6. Cooling-water tank
7. Clutch
8. Hydrostat
9. Blower fan
1. Sweeping pattern adjusting lever
2. Fuse box
3. Air cleaner
1. Hydraulic oil filler inlet and oil dip
stick
2. Battery
1. Engine oil dip stick
BEFORE OPERATION FOR THE
FIRST TIME
Unloading instructions
The machine was secured on a pallet
with stretch belts or ropes for safe
transport.
Proceed as follows when unloading:
! Cut the plastic packing tape and
remove the film.
! Remove the blocks for securing the
wheels and drive the machine off
the pallet using a suitable ramp.
Do not use a fork lift for unloading;
this could damage the machine.
First installation
! Check the tyre air pressure.
♦ See "Technical Data"
! Mount the side broom.
! Commission the battery.
! Install battery.
! Refill fuel
♦ See "maintenance work"
Moving the sweep machine without
own drive
When the machine is not self
powered, do not move it over longer
distances or at speeds higher than
6 km/h.
This can damage the hydraulic
system.
! Lock the hand brake.
! Pull fairing upwards.
! Unscrew hand screw at the inside
of the unit cover.
! Tilt unit cover frontwards onto cable
stop.
! Turn freewheel spigot at hydraulic
pump by 90°.
! Tilt back unit cover.