Installation
After pressing the or button, an
Confirm by pressing .
The following message appears:
You can now use the , and or buttons to make the entry corresponding to your receiving system in the corresponding
positions and exit the menu by pressing 3x. The new station data are stored simultaneously.
Under "Operation" enter whether your active antenna is to receive its power supply from the receiver.
Under "Standby" enter whether the power supply is to be switched off in receiver standby.
To enter network names
Set the bar cursor in the required network position and press . Set the bar on the name, the first letter is marked. You can now change the network name with the aid of the number buttons. The procedure is described in the Section "Operating Information".
To remove a network
Pay attention to the help information on the individual menu items you can obtain by
pressing the button!
To remove a network, go to "Network configuration", move the cursor
bar with the or buttons and press or . You will now be asked whether you wish to remove the network and you can confirm
by pressing or cancel with .
46
