Kathrein UFD 570/S manual Network selection, Software and channel list update

Setting System Parameters

Network selection

You can now select the required positions with the buttons:

•Depending on whether a network is already set, after pressing the

or button in the required position you will be asked whether you wish to delete or add the network. If add is selected, the cursor will jump to "Operation".

•Under "Operation" use or to set whether you have an active antenna requiring power supply from the receiver.

•Under "Standby" enter whether the power supply for the antenna is to be switched on or off in standby mode.

Factory setting

In this position, you can reset all settings to the factory settings by

pressing . The factory settings need not necessarily correspond to the settings required for your receiving system! After the reset, you may have to carry out the entire set-up procedure necessary for your receiving system.

Software and channel list update

Thanks to digital technology, the software and channel list of your receiver can be updated in signal reception mode. The software download submenu will inform you whether new software or a new channel list is available. The only precondition is that your receiving system is aligned and set to a service channel.

54