CHANGING THE DRUM LIGHT
The dryer light automatically turns on inside the dryer drum when you open the door.
To replace bulb:
STEP 1. Unplug power supply cord or turn off electrical power supply.
STEP 2. Open the dryer door. Remove the screw that holds the lens in place.
STEP 3. Remove the lens by pulling it down and away from drum.
STEP 4. Push tab to allow bulb to
swing out.
STEP 5. Check that the light bulb is screwed in tightly. The vibration of the dryer may cause the bulb to come loose. If this is not the problem, remove the light bulb by turning it counterclockwise.
IMPORTANT: Replace the bulb with a
STEP 6. Install light bulb by turning it clockwise.
STEP 7, Push bottom of light and socket assembly in until tab locks.
STEP 8. Place the top of the lens onto the top of the holder. Rotate the bottom of the lens down until it is in place.
Replace screw. NOTE: It is very impor- tant that the lens is replaced properly.
STEP 9. Plug in power supply cord or turn on electric supply.
MOVING CARE
•Unplug power supply cord or turn off electrical power supply.
•Make sure leveling legs are secure in dryer base.
•Use masking tape to secure dryer door.
VACATION CARE
•Unplug power supply cord or turn off electrical power supply.
•Wash lint screen.
37
