Kenmore 3405602 owner manual III. Make FOUR-WIRE, Electrical Connection to Receptacle, Neutral

III.MAKE FOUR-WIRE

ELECTRICAL CONNECTION TO RECEPTACLE

Use a 4-wire power supply cord:

Electrical Shock Hazard

Turn power'supply off before ('onnecting cord.

Use a new 30-ampere power supply cord.

Plug into a grounded outlet. Failure to follow these instructions

(;an result indeath, fire, or electrical shock.

Local codes may permit the use of a U.L.-listed, 120/240-volt minimum, 30-ampere, dr_,er power supply cord kit (pigtail). Power supply cord should be "type SRD or SRDT and be at least fou="feet long. The wires that connect

to the dryer must end with ring terminals or spade terminals with upturned ends.

NEUTRAL		NEUTRAL
/	3/4",U.L.-listed,	(white)
J	strainrelief	\(_

prongwire (green) terminals

Four-wire power supply cord

(Mobile home or other four-wire installations)

For mobile homes or other four-wire inst,allations, the power supply cord must have four, No.-10 copper wires and match a four-wire receptacle

of I_!EMA Type 14-30R. The fourth wire. (grounding conductor) must be identified with a green cover or bare copper wire and the neutral conductor by a white cover.

Four-wire receptacle (NEMA Type 14-30R)

Do not use an extension cord with this dryer.

Do not connect plug end of power supply cord into a live receptacle before

connecting power supply cord to dryer terminal block.

GROUNDING INSTRUCTIONS

This appliance must be grounded.

In the event of malfunction or break- down, grounding will reduce the risk

of electric shock by providing a path of least resistance for electric current.

The power supply cord must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment-grounding conductor carl result in a risk of electric shock. Check with a qualified electrician or serviceman if your are in doubt as to whether the appliance is properly grounded.

Do not modify the plug on the power supply cord. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.

STEP 1. Turn power supply off.

STEP 2. Remove hold-down screw and terminal block cover.

Hold-downscrew Terminalblockcover

36