Kenmore 3405602 It is your responsibility, Quincy, Massachusetts, Electrical Connection Options

C. MAKE ELECTRICAL

CONNECTION

It is your responsibility:

•To contact a qualified electrical installer.

. TO assure that the electrical installation

i._;adequate and in conformance with the National Electrical Code, ANSI/ NFPA 70-latest edition and all local codes and ordinances.

Copies of the code standards listed above may bE; obtained from:

National Fire Protection Association

Batterymarch Park

Quincy, Massachusetts 02269

ELECTRICAL CONNECTION OPTIONS

If Your Home Has:

A 3-wire electrical

receptacle

(NEMA Type 10-30R)

3-wire direct

A 4-wire electrical receptacle

(NEMA Type 14-30R)

ELECTRICAL REQUIREMENTS

The proper electrical connection ensures a safe installation that meets local code requirements.

A three-wire or four-wire, single phase 120/240-volt, 60-Hz., AC-only, electrical supply (or three-wire or four-wire, 120/208-volt if specified on serial/rating plate) is required on a separate 30-ampere circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended.

This dryer is manufactured with the 3-wire, frame-grounding conductor connected to the NEUTRAL (center) of the wiring harness of the terminal block. Do not have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit could result in an electrical shock.

Use a 4-conductor cord when the

dryer is installed in a mobile home or an area where local codes do not

permit grounding through the neutral.

And You Will	Be	Go To
Connecting	To:	Page
A U.L.-listed,	120/240-volt	12-1.
minimum, 30-amp., dryer
power supply cord*
A fused disconnect or		13-11.
circuit breaker box.*
A U.L-listed,	120/240-volt	16-111.

minimum, 30-amp., dryer power supply cord.

	J
4-wire direct	A fused disconnect or	18-IV.
	circuit breaker box.

"If local codes do not permit the connection of a frame-grounding conductor to the neutral wire, see the instructions on page 15.

11

F