Kenmore 790.489, 790.488 manual Lower Oven Self-CleaningCycle, Self=Clean Cycle, Press FLEX CLEAN

Lower Oven Self-Cleaning Cycle

SELF=CLEAN CYCLE

The FLEX CLEAN pad controls the Self-Cleaning feature. When used with a Delay Start pad, a delayed Self-Cleaning cycle may also be programmed. The Flex Clean feature allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00). You may also choose the clean time in 1 minute increments (for example 2 hours and 50 minutes) by pressing the corresponding number keypads.

If you are planning to use the oven directly after a self=clean cycle remember to allow time for the oven to cool down and the oven door to unlock. This normally takes about one hour. So a 3 hour self-clean cycle wiii actually take about 4 hours to complete.

*It is recommend to use a 2 hour self-clean cycle for llghf soils, a 3 hour cycle for overage soils, and a 4 hour cycle for heavy soils (to assure satisfactory results).

NOTE: The kitchen area should be well ventilated using an open window, ventilation fan or exhaust hood during the Self-Clean cycle. This wiii help eliminate the normal odors associated with the Self-Clean cycle.

See example below to start an immediate Self-Cleaning cycle or to set a Delay Start time of 9:00 o'clock and shut-

off automatically (example provided is a default 3 hour Self-Clean cycle)

. Be sure the clock is set with the correct time of day, the

oven is EMPTY and the oven door is closed.

2.Press FLEX CLEAN.

The control wiii automatically clean for a 3 hour period (default self-cleaning cycle time). Note: If a 2 or 4 hour clean time is desired, press 2 0 0 for 2 hour or press 4 0 0 for a 4 hour clean time. Set the cleaning time based on the amount of soih lighh medium or heavy (_See above).

. Press START.

As soon as the control is set, the motor driven oven door

loci< will begin to close automatically. Once the door has been locked the "DOOR LOCKED" indicator light will stop flashing and remain on.

Note: Allow about 15 seconds for the oven door loci< to close.

Nofe: If fhe opflonal delay Self=Clean feafure is needed, finish sfeps 4-6.

4.Press DELAY START.

5.Enter the desired Self-Clean starting time using the number pads 9 00.

6.Press START.

The control wiii calculate forward from the set start time

to determine when the Self-Cleaning cycle should end.

The Self-Cleaning cycle will turn on automatically at the set time.

°To avoid possible burns use care when opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the Self-Cleaning cycle has completed. The oven may still be

VERY HOT.

When fhe Self=Clean Cycle is Complefed

Once the oven has cooled down for approximately 1 HOUR, and the "DOOR LOCKED" icon is no longer displayed, the oven door can then be opened.

Stopping or Inferruptlng a Self=Cleanlng Cycle

If it becomes necessary to stop or interrupt a self-cleaning cycle due to excessive smoke or fire in the oven:

1.Press STOP.

2.Once the oven has cooled down for approximately 1 HOUR, and the "DOOR LOCKED" icon is no longer displayed, the oven door can then be opened.

NOTE (30" model only)

A smoke eliminator in the oven vent converts most of the

smoke into a colorless vapor.

If a self-clean cycle was started but did not finish due to a power failure, your oven may not be completely cleaned. After power has been restored and the oven door has unlocked, set for another self-clean if needed.

36