Kenmore 790.99013, 790.99019, 790.99014 manual General Care & Cleaning, Feature Overview

Models: 790.99014 790.99019 790.99013

1 40
Download 40 pages 27.58 Kb
Page 33
Image 33
Manual background

General Care & Cleaning

FEATURE OVERVIEW

Cleaning Recommendations for Ceramic Glass Cooktops (cont'd)

Care & Cleaning of Stainless Steel

Removing & Replacing Oven Door

Do not use the following on the ceramic glass cooktop:

Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.

Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause discoloration.

Care and Cleaning of Stainless Steel (Stainless Steel models only)

Some models are equipped with stainless steel exterior parts. Special care and cleaning _

are required for maintaining the appearance of stainless parts. Please refer to the table _f>

provided at the beginning of the General Care & Cleaning section in this Use & Care Manual.

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3.Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4.To clean oven door, follow the instructions provided in the General Care & Cleaning table.

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

3.Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the bottom corners of the door as far as they can go.

4.Replace the door mounting screws (See A in illustration).

5.If the door is not in line with the oven frame, remove it and repeat the above steps.

33

Page 33
Image 33
Kenmore 790.99013, 790.99019, 790.99014 manual General Care & Cleaning, Feature Overview