Kenmore 790.99019, 790.99013 manual Setting Clock, Feature Overview, Instructions Press Display

Setting	the Clock
FEATURE	OVERVIEW
• Setting the Clock		_M_DOw
Changing	between	12 or
24 hour display

KI_HEN	O_R	MEA_P_ :,f_KES	BREA_
TIMER	LIGHT
Ot_VOFF	OI_OFF	FOOD CATEGORIES

Setting the Clock

The CLOCK O pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been

interrupted, the timer in the display will flash with "PF" (power failure, See Fig. 1).

Figure 1

INSTRUCTIONS PRESS DISPLAY

To set the clock (example below for 1:30):

1.Press 0" "CLO" will appear in the display (Fig. 2).

2,

Press _ _ _ pads to set the time of day to 1 _30

(Fig. 3). "CLO" wilt appear in the display. Press _. "CLO" will disappear and the clock will start (Fig. 4).

Changing between 12 or 24 hour time of day display:

1.Press and hold O for 6 seconds (Fig. 3). While holding the

pad down the current time of day will remain and "CLO" will disappear from the display (Fig. 4). CONTINUE holding the pad until a beep is heard.

2.The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).

3.Press (_) to switch between the 12 and 24 hour time of day

display. The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).

4. Press _	to accept the change or press _	to reject the
change.

5.Reset the correct time as described in To set the Clock above.

Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

O

OQQ

Q

Ofor 6 seconds

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6

16