NETGEAR WNDAP620 Configure the Optional DHCPv4 Server,  To configure DHCPv4 server settings

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620

Configure the Optional DHCPv4 Server

The wireless access point provides a built-in DHCPv4 server for wireless clients only, which can be especially useful in small networks. When the DHCP server is enabled, the wireless access point provides preconfigured TCP/IP configurations to all connected wireless stations.

Note: For information about how to configure the DHCPv6 server, see

Configure the Optional DHCPv6 Server on page 101.

To configure DHCPv4 server settings:

1.Select Configuration > IP > DHCP Server Settings. The DHCP Server Settings screen displays. The following figure displays the DHCPv4 server settings only. For information about the DHCPv6 server settings, see Configure the Optional DHCPv6 Server on page 101.

Figure 14.

2.Configure the settings as explained in the following table:

Table 5. DHCP server settings for IPv4

Setting

Description

Select the DHCPv4 Server check box to enable the DHCP server. Use the default settings or specify the pool of IPv4 addresses to be assigned by setting the starting IPv4 address and ending IPv4 address. These addresses should be part of the same IPv4 address subnet as the wireless access point’s LAN IPv4 address.

DHCP Server VLAN ID	Enter the VLAN ID for the DHCP server. The VLAN ID range is from 1 to 4094.
	The default VLAN is 1.
Starting IPv4 Address	Enter the first address in the range of IPv4 addresses to be assigned to DHCP
	clients. The default address is 192.168.1.02.

Installation and Basic Configuration

27