ProSafe Premium 3 x 3
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes the wireless access point to reboot.
Table 40. Default configuration settings
Feature | Description | |
|
| |
Login for management and configuration |
| |
|
|
|
| LAN IPv4 management address | 192.168.0.100 |
|
|
|
| Subnet mask for IPv4 management address | 255.255.255.0 |
|
|
|
| LAN IPv6 management address | 2001::21c:c0ff:fe69 |
|
|
|
| Prefix length for IPv6 management address | 64 |
|
|
|
| Required static IPv4 address for management | 192.168.0.210 and 255.255.255.0 |
| computer |
|
|
|
|
| User name | admin |
|
|
|
| Login password | password |
|
|
|
LAN and management features |
| |
|
|
|
| DHCPv4 client | Disabled |
|
|
|
| DHCPv6 client | Disabled |
|
|
|
| Untagged VLAN | Enabled, VLAN ID 1 |
|
|
|
| Management VLAN | VLAN ID 1 |
|
|
|
| SNMP | Disabled |
|
|
|
| Syslog | Disabled |
|
|
|
| Spanning Tree Protocol (STP) | Disabled |
|
|
|
| Link Layer Discovery Protocol (LLDP) | Enabled |
|
|
|
| Secure Shell (SSH) | Enabled |
|
|
|
