
ProSafe Premium 3 x 3
5.Specify the remaining wireless settings as explained the following table:
Table 6. Basic 2.4 GHz band wireless settings
Setting | Descriptions |
|
|
| |
Wireless Network Name | Enter a | |
(SSID) | ||
| device needs to match the wireless access point’s SSID for the wireless device | |
| to communicate with the wireless access point. If the SSIDs do not match, you | |
| do not get a wireless connection to the wireless access point. | |
|
| |
Wireless | This field is not configurable. It shows the status of the wireless scheduler. For | |
| more information, see Schedule the Wireless Radio to Be Turned Off on | |
| page 61. |
|
|
| |
Broadcast Wireless | Select the Yes radio button to enable the wireless access point to broadcast its | |
Network Name (SSID) | SSID, allowing wireless stations that have a null (blank) SSID to adopt the | |
| wireless access point’s SSID. Yes is the default setting. To prevent the SSID | |
| from being broadcast, select the No radio button. | |
|
| |
Channel / Frequency | From the | |
| LAN. The wireless channels and frequencies depend on the country and | |
| wireless mode. The default setting is Auto. | |
| Note: It should not be necessary to change the wireless channel unless you | |
| experience interference (indicated by lost connections or slow data transfers). If | |
| this happens, you might want to experiment with different channels to see which | |
| is the best. For more information, see Operating Frequency (Channel) | |
| Guidelines on page 19. | |
| Note: For more information about available channels and frequencies, see | |
| Technical Specifications on page 139. | |
|
|
|
11ng mode only | MCS Index / Data | From the |
| Rate | Scheme (MCS) index and transmit data rate for the wireless |
Note: For most |
| network. The default setting is Best. For a list of all options |
networks, the default |
| that you can select from in 11ng mode, see Factory Default |
settings work fine. |
| Settings on page 142. |
|
|
|
| Channel Width | From the |
|
| are Dynamic 20/40 MHz, 20 MHz, and 40 MHz. The default is |
|
| 20 MHz. A wider channel improves the performance, but |
|
| some legacy devices can operate only in either 20 MHz or |
|
| 40 MHz. |
|
|
|
| Guard Interval | From the |
|
| transmissions from interference. The default is Auto, or you |
|
| can select Long - 800 ns. Some legacy devices can operate |
|
| only with a long guard interval. |
|
|
|
Installation and Basic Configuration
30