NETGEAR WNDAP620 manual Configure Radius Server Settings

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620

•WPA-PSK & WPA2-PSK

Figure 29.

Table 13. Settings for WPA-PSK, WPA2-PSK, and WPA-PSK & WPA2-PSK

Setting	Descriptions
Data Encryption	TKIP	Temporal Key Integrity Protocol (TKIP) is the standard encryption method
		used with WPA. You can also use TKIP with WPA2.
		Note: TKIP provides only legacy (slower) rates of operation. NETGEAR
		recommends WPA2 authentication with AES encryption if you want to use the
		11n rates and speed.
	AES	Advanced Encryption Standard (AES) is the standard encryption method used
		with WPA2.
		Note: Although some wireless clients might support AES with WPA, the
		WNDAP620 wireless access point does not support WPA with AES.
	TKIP + AES	TKIP + AES supports both WPA and WPA2. Broadcast packets use TKIP. For
		unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2
		clients use AES.
		For the WPA & WPA2 mixed mode, TKIP + AES is the only supported data
		encryption method.
Passphrase	Enter a passphrase. The passphrase length needs to be between 8 and 63 characters
	(inclusive). The default passphrase is sharedsecret.
	You can display the actual passphrase by selecting the Show Passphrase in Clear Text
	Yes radio button.
Show Passphrase	Select the Yes radio button to display the actual passphrase in the Passphrase field. The
in Clear Text	default setting is No.

Configure RADIUS Server Settings

For authentication, accounting, or both authentication and accounting using RADIUS, you need to configure primary servers and optional secondary servers. These RADIUS server settings can apply to all devices that are connected to the wireless access point.

You can configure both IPv4 and IPv6 servers. In the IPv4 Radius Server Settings section, enter IPv4 addresses only; in the IPv6 Radius Server Settings section, enter IPv6 addresses only.

Wireless Configuration and Security

57