Kenmore 911.41785 Oven Control, Clock and Timer, Tones While Setting, To Cancel the 6 Second Beep

OPERATION

Oven Control, Clock and Timer

Your new control has a series of tones that will sound at different times. These

tones may sound while you set the control for an oven function, or at the end of the oven function. It will also alert you that there may be a problem with the functions. Below are the types of tones and a brief description of each,

TONES WHILE SETTING THE

CONTROL When you press a touch pad you will hear a beep. This beep will let you know you have placed enough pressure on the pad to activate it. (The arrow pads do not beep.)

END OF TIMED CYCLE TONE -- At the end of a timed cooking function, you will hear 3 short beeps followed by 1 beep every 6 seconds, This beep will continue to sound every 6 seconds, until the CLEAR/OFF pad is pressed or you may select the special feature to cancel this 6 second beep from sounding at the end of future cycles,

TO CANCEL THE 6 SECOND BEEP

1.Press and hold the BAKE and BROIL pads, at the same time

for 3 seconds, until the display shows I_SF_.

2.Press the KITCHEN TIMER

ON/OFF pad. The display will show "CON BEEP" (continuous beep).

3.Press the KITCHEN TIMER ON/OFF pad again. The display will show "BEEP" (beep canceled).

4, Press the START pad to cancel the 6 second beep and leave the special feature mode.

If you would like to return the 6 second beep, repeat steps above until the display shows your choice and press the START pad.

ATTENTION TONE -- This tone will

sound if you make an error or an

oversight is made while setting an oven function.

Examples would be:

a, Setting a clean cycle and the oven door is not properly closed.

b, Setting function and not pressing the START pad.

e. Pressing an additional function pad

without first setting a temperature or time.

Any of these can be quickly identified by watching the display.

PREHEAT TONE -- When you set an oven temperature, the oven automatically starts to heat. When the temperature inside the oven reaches the temperature you have set, a tone will sound to let you know the oven is ready for baking.

If you set an oven function and the

control beeps while the display is flashing "F" and a number or letter

such as "F-4" or "Fr' there may be a problem with the control or oven.

Simply press the CLEAR/OFF pad and wait about an hour. Try setting the function again. If the code repeats, write down the flashing code and call for service. Teit the technician what code was flashing.

9