The voice activation setting function allows the user to record desired words for use in voice activation.

The user can switch the system from standby mode to ON mode by speaking the recorded words.

However, note that voice activation using preset “KENWOOD” is not possible when the user’s words are recorded for voice activation.

System component startup by voice activation

C-V750 (En/T)

Note for voice activation recording

21

The words for use in voice activation should be recorded in an quiet environment. Correct recording may sometimes be impossible in a noisy environment.

When using the voice activation function, too, adjust the microphone position so that it does not pick up noise.

Recording the user’s own voice for voice activation (by specific person)

One as well as more than one word can be recorded for use in voice activation.

Main unit

1Press the VOICE ACTIVATE SET key to ON.

VOICE

ACTIVATE

ON/OFF SET

2 The indicator lights in amber.

Ö Up to 5 words can be recorded provided that they are spoken in less than

about 12 seconds. If a long word is recorded, the total number of words

which can be recorded may become less than 5.

Ö Either one user can record up to 5 words or up to 5 users can record one

word per person.

Ö If more than the specified number of words are recorded, the words

recorded earlier are overwritten by newly recorded words in the order they

were recorded.

Ö “RECORD” is displayed to indicate the status in which voice recording is

(Record-ready mode)

Lights in amber.

possible. “RECORD OK” is displayed when recording has completed

successfully.

3 Record voice (words).

 

(The indicator goes out during recording.)

Goes

Speak desired words into the exclusive mi-

out.

 

crophone in less than 2 seconds.

 

4Repeat steps 2 and 3 until “RECORD OK” is displayed. (Repeat 3 times or more.)5Now the recording is completed.

(The indicator lights in green.)

Lights in green.

 

Ö Repeat steps 1 to 5 if you want to record another word.

ÖIf recording failed, the display lights in red and shows “RECORD NG”. In this case, restart the procedure from step 1.

To erase the recorded voice

Main unit

1Press and hold the VOICE ACTIVATE SET key for more than 5 seconds.2The entire recorded voice is erased.

ÖWhen the recorded words are erased, the unit returns to the status which allows "Starting the system components by voice activation ( by any person ) specified by ”KENWOOD“.

Starting the system by voice activation using the recorded words (by specific person)

Preparation for voice activation operation

Main unit

1Ensure that the exclusive microphone is con-nected.5

2Press the (ON/STANDBY) key to ON mode.

3 Press the OPEN/CLOSE key to open the door.

4 Press the VOICE ACTIVATE ON/OFF key to ON (so that the indicator lights in green).

5 Close the door.

Lights in green.

 

6Press the (ON/STANDBY) key to STANDBY mode

(so that the display shows the clock information).

ÖLoad the CD player or LD player with the software to be played.

ÖIf the indicator lights in red, the unit is in the status which allows “Starting the system components by voice activation (by any person)”.

Operation for voice activation of system components (by specific person)
1Speak the recorded words into the exclusive microphone.

2The system components are switched from standby mode to ON mode. The input selection is switched to CD or LD, and the corresponding component starts playback.

ÖIf both the CD player and LD player have been connected, the CD player is given the precedence.

ÖThe auto power-save operation also occurs after the system compo- nents are turned ON by means of voice activation by specific person.

)