11
Remote control unitSymptom | Cause | Remedy |
|
| Remote control operation is not possible. | Ö Batteries are exhausted. | Ö Replace with new batteries. | # |
| Ö The remote control unit is too far away from the | Ö Operate the remote control unit within the | |
| main system, controlling angle is too large, or | controllable range. | @ |
| there is an obstacle in between. |
|
|
| Ö The audio cords and system control cords are | Ö Connect properly referring to “System con- | |
| not connected properly. | nection”. | 58 |
| Ö The source component to be operated does not | Ö Place the tape(s) or disc in the source compo- | |
| contain the tape(s) or disc. | nent to be played. |
|
|
|
|
|
| The GRC screen is not displayed. | Ö Batteries are exhausted. | Ö Replace with new batteries. | # |
|
|
| |
| The GRC display is abnormal. | Ö Batteries are removed while something is dis- | Ö Remove and replace batteries after the infor- | |
| played. | mation display has disappeared. | |
|
|
|
|
Set up code chart
Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain codes may only operate some of the functions available on a given model.)
With some models, be sure to keep the ENTER key pressed for a while.Memory backup functionPlease note that the following items will be deleted from this unit’s memory if the power cord is disconnected from the AC outlet for approximately three days.
ÖThe input selection is cleared and the TUNER input is selected.
ÖThe volume setting is cleared and the volume is set to
ÖThe receiving band setting is cleared and the FM band is selected.
ÖThe frequency setting is cleared and 87.5 MHz is selected.
ÖThe preset station memory is cleared.
ÖThe voice activation setting is cleared and the activation by non- specified person is set.
ÖThe surround setting is cleared and reset to the initial condition.
ÖThe clock and timer setup is cleared and the clock display shows AM 12:00 which is blinking.