Setup of the Graphical Remote Control (GRC) unit
Setting up the GRC according to other components (Set Up) | 15 |
|
The GRC can also be used to remote control other components which are not connected through system control cords. To control another component, it is required to register the setup code corresponding to it beforehand. E
Main Menu |
|
|
|
|
| Input | ENTER |
CD | Tuner | LD | Tape1 | TapeA | Source | ||
Return Cable | Sat. | TV VCR1 | VCR2 | TapeB | Set Up Confirm | VOLUME | |
Setup |
|
|
|
|
|
|
|
C D |
| L D | Tape1 VCR1 |
| |||
Sat. |
| T V | Cable | VCR2 |
| ||
DVD/6ch Input |
|
| MUTE | ||||
|
|
|
Sound Speaker Reset
ON/STANDBY
Main operation menu
(The displayed icons are variable depending on the model.)
1Find the setup code of the component to be registered by referring to the Setup code chart in this manual.
2Enter the setup code.
1 Select the ”Set Up“ icon. |
| Check the operation of the component. |
| Set Up | 1 Display the operation screen of the component to be checked. |
|
| 2 Turn on the component from the GRC and confirm the |
2 Enter the selection |
| actual component. |
ENTER | Ö If there is more than one setup code, input each code to see | |
(by pressing the ”ENTER“ key). |
| |
| which one turns the power on. That will be the correct code for | |
|
| |
|
| your component. |
3 Select the ”VCR 1“ icon. | VCR1 |
|
|
| |
4 Enter the selection | ENTER | Although each setup code is designed to work with a |
(by pressing the ”ENTER“ key). |
| Note number of different models, certain codes may not work |
| 1 2 3 | with some models. (Also, certain codes may only operate |
| some of the functions available on a given model.) | |
5 Enter the setup code. | 4 5 6 | With some models, be sure to keep the ENTER key |
pressed for a while. | ||
Set | 7 8 9 | Use the numeric keys as shown below. |
000 |
| |
0 | Entry examples: |
6Select the ”Set“ icon.
Set
431
431 ..... | 4 |
400 ..... | 4 |
ENTER
ENTER
3
)
ENTER
ENTER
1
)
ENTER
ENTER
7Enter the selection
(by pressing the ”ENTER“ key).
ENTER
ÖWhen a code which is not shown in the setup code chart is entered, the entered code disappears automatically.
The procedure of steps 1 and