Controls and indicators
10
Opening/closing the door
OPEN/CLOSE
Note | When opening or closing the door, be careful not to catch |
your finger in the door. Otherwise there is a risk of injury. |
Changing the input selection display (AUTO key)
*1: To change the TAPE 1 display to MD display1Select “TAPE 1” with the INPUT SELECTOR .2Press and hold the AUTO key for more than 2 seconds, until “MD” is displayed.Each press switches the indication.
1 TAPE1 |
| 2 MD |
|
2Press and hold the AUTO key for more than 2 seconds, until “6 ch INPUT” is displayed.
Each press switches the indication.
To make the system control operation, the input selection display should be switched according to the actually connected compo- nents.
About the system control connections | 8 |
1 |
| 2 6ch INPUT |
|
Switching the display mode (DISPLAY key)
Use the following procedure to change the display mode.1Press the DISPLAY key (remote control only).Each press switches the indication.
1INPUT SELECTOR 2 DOLBY/DSP/ 3 Timedisplay | STEREO | display |
| display |
|
ÖThe time display is displayed for only 5 seconds, after which the INPUT SELECTOR display appears automatically.
ÖThe display of 2is not shown during SOURCE DIRECT and 6ch INPUT operations.