Other features

English

Audio Control Setting

Adjust various sound levels.

1Press the AUD button to enter the control mode.

2Press either the 4 or ¢ button.

Each time the button is pressed, the adjustment mode will change as follows:

Pressing the ¢ button advances the display, and pressing the 4 button reverses it.

Balance

Fader

N-F Level (only when being switched)

 

 

 

 

 

 

 

 

3Press the FM/AM button.

Look at the table to adjust the mode being displayed.

Adjustment

Operation of Audio control button

mode

 

 

(Display)

AM button

FM button

Balance

Left channel emphasized.

Right channel emphasized.

("Balance")

 

 

 

 

 

Fader

Rear channel emphasized.

Front channel emphasized.

("Fader")

 

 

 

 

 

Non-Fading

Front and rear

Non-fading sound

Preout Level

channels (including

emphasized.

("N-F")

preout) emphasized.

 

 

 

 

4Press the AUD button to end the control mode.

Security Code

When the battery is removed from the unit's power switch, you cannot turn on the unit again unless the preset security code is input. This function helps prevent theft.

NOTE

You must follow steps 1 to 9 to be able to use the Security Code function. Turning off the power during the procedure will deactivate the security code setting.

Once the security code function has been activated, "CODE STBY" disappears from the function set system. Note that it will no longer be possible to cancel this function afterwards.

1Select the four digits to use in your security code.

NOTE

The four-digit security code is very important, as you will need it to turn the unit on again when the code security function is on. Choose the number carefully and do not forget it (write it down and keep it separately in a safe place).

2Press the SRC button repeatedly and switch the display to "ALL OFF" to enter the standby mode.

3Press the FNC button.

"Function Set" is displayed and the function set mode is turned on.

4Keep pressing the ¢ button until the “CODE STBY” appears in the display.

Press the 4 button to search in the other direction.

5Press either the AM or FM button for at least two seconds. "CODE WRITE" will appear in the display for one second, indicating the code setting mode has been entered. When "CODE ✽✽✽✽" appears in the display, you can start inputting the code.

6Press the preset button and enter the security code that you have selected in step 1.

Example: Use "3510" as the security code.

— 28 —