Step

Button to press

# Times

Display

pressed

 

 

 

1

#1

4

“3”

2

#2

6

“5”

3

#3

2

“1”

4

#4

1

“0”
7Press the 38 button.The security code will be set.

"CODE ✽✽✽✽1" appears in the display, asking you to enter the code once again for confirmation, and then you can start inputting the code.

8Press the Preset button and input the security code again.9Press the 38 button again.

"CODE WRITE" will appear in the display, with the security code function turning on. From this point on, if the unit is disconnected from the battery, the security code must be entered the first time that the unit's power is turned on. "CODE" will appear in the display, asking you to input the code.

NOTE

If you input an incorrect security code, the display ask you once more to input the correct one. Follow the procedure in step 6 above.

If you press the RESET button or remove the battery:

The first time you turn the unit on again, "CODE ✽✽✽✽" will appear in the display, asking you to input the security code. Repeat steps 8 and 9 above, and input the security code.

You can start operating the unit again when "CODE OK!" appears in the display.

If you enter the incorrect code, the power will turn off. Enter the correct code to turn the unit on.

Panel Angle AdjustmentYou can adjust the panel angle for easy viewing.
Sliding the panel:Press the ANGLE∞ button.Each time you press the ANGLE∞ button, the panel will slide one step at a time.

NOTE

If the power is turned off, the panel will close automatically. When you turn the power back on, the panel angle will return to the adjusted angle position.

Closing the panel:Press the 5RETURN button to close the panel.

NOTE

The sound will be muted while the panel is sliding during the tape mode.

2CAUTION

•Take care that your fingers and so on do not get caught during the slide operation of the front panel.

•When the front panel has been slid, it might interfere with the shift lever or something else. If this happens, pay attention to safety and move the shift lever or take an appropriate action, then operate the unit.

•Do not apply excessive force to the front panel after it slides.

Switching Display

You can switch the display during the standby mode as mentioned below.Switching the Display During the Standby Mode:

Each time you press the DISP button during the standby mode, the display switches as follows:

Character

Clock with graphic display

Clock

— 29 —