Station Name Preset (SNPS)

You can assign names to radio stations with the Station Preset Memory. Up to 30 stations can be assigned names.

1Adjust the frequency to the station whose name you want to enter.

NOTE

This function cannot be available during the clock display.

2Press the NAME.S button for at least two seconds.

“Name Set” is displayed once the station name preset mode is entered.

The cursor will blink in the position where letters are entered.

3Press either the 4 or ¢ button to move the cursor to the desired position.

The 4 button moves the cursor to the left, and the ¢ button to the right.

You can also move the cursor left or right by pressing the 4 or ¢ buttons, respectively, on the remote.

4Each time the 38 button is pressed, the characters to be entered change as listed below.

Press the FM or AM button to display the desired character. Characters that can be displayed are as follows.

Alphabet (upper case): A ~ Z

Alphabet (lower case): a ~ z

Numerals and symbols: _ 0~9 / + - ✽ = & " ˚ ' < > [ ]

5Continue steps 3 and 4 until all the characters are chosen for the name.

NOTE

You can enter up to 8 characters for each name.

6Assigning Names

Press the NAME.S button on the unit or the OK button on the remote.

The name of the station is stored in memory, and the Station

Name Preset mode ends.

Also, if you make no input for 10 seconds, the name will be stored up to the point that you have entered, and the mode ends.

NOTE

•You can assign names to up to 30 FM/AM stations in all.

•Station names remain stored even if the reset button is pressed.

•If you want to change the name of a station, first display the name of the station (following steps 1 and 2 above), then change the letter(s) that you want by following steps 3 and 4.

Switching Display for Tuner

You can change the display used when listening to the radio.

Changing the Display:

Each time you press the DISP button, the display changes as follows:

Station frequency

SNPS name (only when being preset)

Character

Clock

— 9 —