English
Removing the Unit
■Removing the Unit
1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2Remove the screw (M4 ⋅ 8) on the back side.
3Insert the two removal tools deeply into the slots on each side, as shown.
Screw (M4X8) | Accessory2 | |
Removal tool | ||
(commercially | ||
|
available)
4Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards the inside.
Be careful to avoid injury from the catch pins on the removal tool.
5Pull the unit all the way out with your hands, being
careful not to drop it.
Locking the Backpanel to the unit
1Refer to the Removing the Backpanel function of the section on <Theft Deterrent Panel> (page 17) and remove the Backpanel.
2Insert the panel lock screws into the holes at the sides of the panel.
Accessory4
3Reattach the Backpanel.
Never insert the panel lock screws (M2 X 1.5 mm) in any other screw holes than the one specified. If you insert them in another hole, it will contract and may cause damage to the mechanical parts inside the unit.
— 46 —
