Removing the Unit
■Removing the hard rubber frame
1Engage the catch pins on the removal tool and remove the two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
• To attach this unit, make sure the front of the control panel faces you |
and fit it into the mounting sleeve by pressing the four corners of the |
hard rubber frame at the same time. |
Lock
Accessory2
Removal tool
Catch
Do not apply strong pressure to other sections than the corners; |
otherwise troubles such as the impossibility of opening or closing the |
panel may result. |
• The hollow at the center of the rubber frame is designed to make it |
easier to remove discs. |
If you do not want the hollow to be visible, mount the rubber frame in |
the opposite direction (with the flat side at the top instead of the |
bottom). |
2When the upper level is removed, remove the lower two locations.
The frame can be removed from the bottom side in the same manner.
— 45 —
