Kenwood KDC-M7024, KDC-7024 instruction manual Audio Control, 1st section, 2nd section, 3rd section

General features

English

Audio Control

1Select the source for adjustment Press the [SRC] button.

2Select the key function section Press the [NEXT] button.

Repeatedly press the button until "AUD" is displayed above the [2] button.

Refer to <Notes on Multi-function Key System> (page 8).

3Enter Audio Control mode Press the [2] ("AUD") button.

4Select the Adjustment item section Press the [NEXT] button.

Repeatedly press the button until the desired Adjustment item is displayed above the [2] — [5] button.

1st section
	Adjustment Item	Button	Display
	Bass	[2]	"BASS"
	Middle	[3]	"MID"
	Treble	[4]	"TRE"
	Balance & Fader	[5]	"BL/F"
2nd section
	Adjustment Item	Button	Display
	High Pass Filter	[2]	"HPF"
	Low Pass Filter*	[3]	"LPF"
	Loudness	[4]	"LOUD"
	Non-Fading*	[5]	"N-F"
3rd section
	Adjustment Item	Button	Display
	Volume offset	[2]	"VOFF"

5Select the Audio Control item for adjustment Press the [2] — [5] button.

Each time the [2] — [5] button is pressed the adjustable audio items are switched among ranges of all stage section's tables on the following pages.

6Adjust the Audio Control item Press the [4] or [¢] button.

Each time the button is pressed the setting switches as shown below.

7Exit Audio Control mode Press the [RTN] button.

• The loudness setting can also be adjusted by pressing the [4] button.

•*This mode is available only when <Non-fading Output> (page 16) is ON.

1st section
[2] button
	Adjustment Item	Display	Range
	Bass Center	"Bass F"	60/70/80/100 or 150 Hz
	Frequency
	Bass level	"Bass"	–8 — +8
	Bass Q Factor	"Bass Q"	1.00/1.25/1.50/2.00
	Bass Extend	"Bass EXT"	ON/OFF

— 12 —