Troubleshooting Guide

English

The messages shown below display your systems condition.

EJECT:

No disc magazine has been loaded in the changer. The disc

 

magazine is not completely loaded.E01

 

Load the disc magazine properly.

 

No CD in the unit.

 

Insert the CD.

No Disc:

No disc has been loaded in the disc magazine.E02

 

Load a disc into the disc magazine.

TOC Error:

No disc has been loaded in the disc magazine.E04

 

Load a disc into the disc magazine.

 

The CD is quite dirty. The CD is upside-down. The CD is

 

scratched a lot.

 

Clean the CD and load it correctly.

E-05:

The CD is upside-down.E05

 

Load the CD correctly.

Blank Disc:

Nothing has been recorded on the MD.E10

No Track:

No tracks are recorded on the MD, although it has a title.E11

E-15:Media was played that doesn’t have data recorded that the unit can play. E15

Use media that has data recorded that the unit can play.

No Panel:

The faceplate of the slave unit being connected to this unit

 

has been removed.E30

 

Replace it.

E-77:The unit is malfunctioning for some reason.E77

Press the reset button on the unit. If the "E-77" code does not disappear, consult your nearest service center.

Mecha Error:

Something is wrong with the disc magazine. Or the unit is

 

malfunctioning for some reason.E99

 

Check the disc magazine. And then press the reset button

 

on the unit. If the "Mecha Error" code does not disappear,

 

consult your nearest service center.

Hold Error:

The protective circuit in the unit activates when the

 

temperature inside the automatic disc changer exceeds 60°C

 

(140°F), stopping all operation.E0d

 

Cool down the unit by opening the windows or turning on

 

the air conditioner. As the temperature falls below 60°C

 

(140°F), the disc will start playing again.

NO NAME:

Attempted to display DNPS during the CD play having no disc

 

names preset.E51

Waiting:

Radio text data is being received.E56

Load:

Discs are being exchanged in the Disc changer.E57-1

Reading:

The unit is reading the data on the disc.E57-2

NO ACCESS:

After setting it in the Disc Changer, DNPP was done without

 

having it been played at least 1 time.E58

IN (Blink):

The CD player section is not operating properly.E59

 

Reinsert the CD. If the CD cannot be ejected or the display

 

continues to flash even when the CD has been properly

 

reinserted, please switch off the power and consult your

 

nearest service center.

— 50 —

Page 50
Image 50
Kenwood KDC-M7024, KDC-7024 instruction manual Messages shown below display your systems condition