General features

Display Type E

G-Analyzer display Switching

Alternates G-Analyzer display when the Display type is set to "Display Type E". (G: gravity)

•Before alternating G-Analyzer display, you are required to setup <G-Counter Level set> (page 42), <G-Analyzer Calibration setup> (page 42) and <G- Analyzer Horsepower Gauge setup> (page 43).

1Select the key function section Press the [NEXT] button.

Repeatedly press the button until "DISP" is displayed above the [2] button.

Refer to <Notes on Multi-function Key System> (page 9).

2Enter display control mode Press the [2] ("DISP") button.

3Select the display mode Press the [1] ("MODE") button. Select the "Display Type E" display.

4Enter G-Analyzer display select mode Press the [3] ("GMENU") button.

5Select the G-Analyzer display

Push the Control knob towards [4] or [¢].

G-Force Sensor display

 

G- Graphic display*

 

G-Meter display

 

(Graphic)

 

G-Meter display

 

(Text)

Point

G-Counter display

 

Time

•G-Graphic display

Displays the condition of G in horizontal direction (e.g; when turning the curve) by the graphic.

•* G-Graphic can be switched to customized pictures. Refer to <Picture downloading> (page 49) and <G- Graphic Select> (page 44). (KDC-X790 only)

•G-Meter display (Graphic)

Displays the maximum value of acceleration G, right direction G, and left direction G by the numerical value.

•G-Meter display (Text)

The maximum value of acceleration G, right direction G, and left direction G is displayed by the numerical value. The value of G is only the reference, so is different from the actual value.

•G-Counter display

Adds the point of the acceleration level. The point is determined after a lapse of 1 hr drive or at power off (ACC Off), and then it will be displayed by the graph. Furthermore, the G-Counter displays the average of the past data by the line. (The scale of graph is determined along with the largest point among the past 10 data.)

•The value of G-Meter display and G-Counter display can be reset by <G-Analyzer Reset> (page 42).

6Exit display control mode Press the [6] ("RTN") button.

22 English