Setting up the system

¤CAUTION

Do not connect the power cord to a wall outlet until all connections are completed.

Make connections as shown in the following pages.

When connecting the related system components, be sure to refer to the instruction manuals supplied with the components you are connecting.

•Be sure to insert all connection cords securely. If their connections are imperfect, the sound may not be produced or there will be noise interference.

•Be sure to remove the power cord from the AC outlet before plugging or unplugging any connection cords. Plugging/ unplugging connection cords without disconnecting the power cord can cause malfunctions and may damage the unit.

•If this unit is installed in the proximity of a source of magnetism such as a magnet, color irregularities due to interference with the speakers may be observed on the TV screen. Be careful in the installation.

Microcomputer malfunction

If operation is not possible or an erroneous display appears, even though all connections have been made properly, reset the microcomputer by referring to <Troubleshooting>. r

¤CAUTION

The power of this equipment will not be completely cut off from the wall outlet when the power switch is turned off. Install the equipment so that the wall outlet is easily accessible and, in case of emergency, immediately unplug the power cord from the wall outlet.

¤CAUTION

Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard.

•Do not place any object on the unit that may hinder heat radiation.

•Do not cover the unit with a cloth or install the unit on a carpet or mattress.

•Do not install the unit in a poorly ventilated place.

•Leave some space around the unit (from the largest outside dimension including projection) equal to or greater than, shown below.

Top panel : 50 cmSide panel : 10 cmBack panel : 10 cm

Speaker placement

Front speaker

 

 

 

Front speaker

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Subwoofer

Center speaker

 

 

Listening

Surround speaker

position

Surround speaker

 

Surround Back speaker (6.1ch)

Surround Back speaker (7.1ch)

Front speakers:

Install in the front left and right positions. Symmetrical installation is ideal. The front speakers are always used regardless of the listen mode.

Center speaker:

Install in the front center position. This speaker improves the acoustic image positioning and reproduction of sound movement.

Surround speakers:

Install straight on or slightly behind the left and right of the listening position, at in an as high as possible height (ideally one meter above the height of the listener’s ears). Symmetrical installation is ideal. The surround speakers reproduce the feeling of movement and presence of sound.

Subwoofer:

In general, install on the front center position near the front speakers. The subwoofer reproduces the powerful bass effects. As it is less directional to other speakers, it can be installed so that the bass can be reproduced best according to the listening room layout.

Surround Back speakers:

Install on the rear of the listening position, at the same height as the surround speakers.

When only one surround back speaker is installed, the system becomes a 6.1-channel surround system. When two surround back speakers are installed, it becomes a 7.1-channel surround system.

•Ideal surround play is possible when all of the speakers above are installed. If the center speaker and/or the subwoofer is not installed, the system optimizes playback according to the current system by assigning the sound of absent channels to other speakers.

10 KRF-V6300D