Speaker setup (Detailed Setup)

Adjusting the speaker level ("TEST TONE")

From your usual listening position, adjust the volume output of each speaker. The output level from each speaker should be the same.

œSee <Getting into the setup mode> (™) and select "TEST TONE".∑Use [MULTI CONTROL ∞/5] to select either "AUTO" or "MANUAL".

Display

Setting

"AUTO"

The test tone is heard from the speakers one after another with

2 seconds each.

 

"MANUAL"

The test tone is heard from the speaker you have selected.

éPress [SETUP].

®Adjust the output level.If you select "AUTO":

When you hear the test tone from the speaker which you wish to adjust, use [MULTI CONTROL ∞/5] and adjust the volume of the test tone. When you finish adjusting, press [SETUP].

If you select "MANUAL":

Use [MULTI CONTROL ∞/5] to adjust the volume of the test tone and press [SETUP]. You will hear the test tone from the next speaker.

Distance setting ("DISTANCE")

This sets the distance from each speaker to the listening position.

œMeasure the distance from the listening position to each speaker and jot down in the table below.

Speaker

Input channel

Distance from the

indicator

listening position

 

Front speaker (left)"L"

feet (meters)

Center speaker"C"

feet (meters)

Front speaker (right)"R"

feet (meters)

Surround speaker (right)

"RS"

feet (meters)

Surround Back speaker (right)

"BS"

feet (meters)

Surround Back speaker (left)

"BS"

feet (meters)

Surround Back speaker*

"BS"

feet (meters)

Surround speaker (left)

"LS"

feet (meters)

Subwoofer

"SW"

feet (meters)

*This selection is available when "BS MONO" is selected in the speaker setup.∑See <Getting into the setup mode> (™) and select "DISTANCE".éUse [MULTI CONTROL ∞/5] to select the distance to the front speaker.Adjustment will start from front left speaker.

Input channel indicator

†Go to the next setting, "DISTANCE".

If you wish to exit the setup mode, see <To exit the setup mode> ™.

®Press [SETUP].†Repeat steps é– ®to input the distance for the rest of the speaker.¥Go to the next setting, "CROSS OVER".

If you wish to exit the setup mode, see <To exit the setup mode> ™.

24 KRF-V6300D