45
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■Selecting Priority Scan Method
This transceiver prepares the following two modes for
Priority Scan. Use mode B when you do not want
Priority Scan to disrupt your current QSO.
Mode A: Monitors the Priority channel every 3 seconds no
matter whether or not signals are being received
on the current operating frequency.
Mode B: Monitors the Priority channel every 3 seconds
only when no signals are present on the current
operating frequency.
1Press [MNU] to enter Menu mode.
2Select Menu No. 11 (PRI).
3Press
[OK]
, then select mode A (default) or
mode B.
4Press
[OK]
again to complete the setting and exit
Menu mode.
■Using Priority Scan
1Press
[F]
, [MNU] to start Priority Scan.
•“PRI” appears.
•When signals are received on the Priority channel, a
beep sounds and the Priority channel is recalled. In
addition, “PRI” blinks.
2Press and hold Mic [PTT] to transmit on the
Priority channel and release Mic [PTT] to receive.
•Approximately 3 seconds after signals drop, Priority
Scan resumes.
3To quit Priority Scan, press
[F]
, [MNU] again.
Note:
◆
When signals are received on the Priority channel programmed
with CTCSS, the Priority channel is recalled; however, the
squelch does not open unless the signals contain the matching
CTCSS tone.
◆
You can simultaneously use Priority Scan and any other type of
Scan; however Priority Scan does not function while the other
scan is being paused.
◆
To monitor the current operating frequency while using Priority
Scan, press and hold the Mic PF key assigned the Monitor
function {page 51}. Release the key to resume Priority Scan.
1
2
1
2