2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
■Installation Steps
1Install the mounting bracket in the vehicle using
the supplied flat washers and self-tapping screws.
There are 4 washers and 4 screws supplied.
•The bracket can be mounted with the bracket
opening for the transceiver facing down for
underdash mounting, or with the opening facing up.
•The bracket must be installed so that the 4 screw
holes on the edge of each bracket side are facing
forward.
2Position the transceiver, then insert and tighten
the supplied hexagon SEMS screws and washers.
There are 2 screws and 2 washers supplied for
each side of the bracket.
•Double check that all hardware is tightened to
prevent vehicle vibration from loosening the bracket
or transceiver.
PREPARATION FOR MOBILE AND FIXED STATION OPERATION

MOBILE INSTALLATION

Install the transceiver in a safe, convenient position
inside your vehicle that minimizes danger to your
passengers and yourself while the vehicle is in motion.
For example, consider installing the transceiver under
the dash in front of the passenger seat so that knees or
legs will not strike the radio during sudden braking of
your vehicle. Try to pick a well-ventilated location that is
shielded from direct sunlight.
■Installation Example
Use the supplied mounting bracket to install the
transceiver inside your vehicle. To enjoy the best
viewing angle, you can position the transceiver in the
bracket in a number of ways as shown below.
Flat washer
Self-tapping
screw
SEMS screw
KENWOOD
FM DUAL BANDER TM-G707