51
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
ASSIGNING SPECIAL KEY FUNCTIONS
1Press [MNU] to enter Menu mode.
2Select Menu No. 20 (PF1) to No. 23 (PF4).
3Press
[OK]
, then turn the Tuning control to select the
desired function.
•As you turn the Tuning control clockwise the selection
changes as shown below:
User Setting ➞ Monitor ➞ Enter (U.S.A./ Canada only)
➞ Voice ➞ PWR switch (PF 1 only) ➞ 1750 Hz Tone
(TM-G707E only)
4Press
[OK]
again to complete the setting and exit
Menu mode.
User Setting:
Selects the front panel key function you assigned
{page 50}.
Monitor:
Makes the squelch open and allows you to monitor
activity on the current frequency. This function is useful
when adjusting the volume or when receiving weak
signals.
•Pressing the re-programmed Mic key switches Monitor ON
or OFF.
•Scan will not function if Monitor is ON (squelch open).
Enter (U.S.A./ Canada only):
Allows you to enter digits from the MC-53DM
microphone. Refer to “KEYPAD DIRECT ENTRY”
{page 54}.
Voice:
Activates or deactivates function that announces the
current frequency using beeps of different frequencies.
Press any key to stop the beeps.
(POWER) switch:
Turns the transceiver ON or OFF. This function can be
assigned only to PF 1.
1750 Hz Tone (TM-G707E only):
After releasing the re-programmed Mic key with Transmit
Hold ON, the transceiver remains in the transmit mode for
2 seconds; a 1750 Hz tone is not continuously transmitted
for 2 seconds. A 1750 Hz tone is continuously transmitted
only while the re-programmed Mic key is being held.
•You can also use Transmit Hold to continuously send a
1750 Hz tone for 2 seconds after releasing the
re-programmed Mic key. To activate this function, access
Menu No. 26 (T.HLD) and select ON.