Kenwood TS-590S instruction manual ,63/$, Abcd

*(77,1*$&48$,17('

/&'',63/$<

ABCD

EF

—— A ——

Appears when the Noise Blanker 1 or 2 is ON {page 40}.

While receiving, the meter serves as an S-meter to measure and display the received signal strength. While transmitting, it serves as a power meter plus an ALC meter, an SWR meter, or a Speech Processor compression meter. The Peak Hold function holds each reading for approximately half a second. While adjusting the IF filter bandwidth, the meter displays an adjustment state.

“	” (fast) or “	” (slow) appears when the
Automatic Gain Control function is ON. “			”
appears when the AGC is OFF {page 29}.

Appears when IF filter A is selected {page 39}.

Appears when IF filter B is selected {page 39}.

—— B ——

Appears when the Auto Mode function is ON and while in Auto Mode frequency setup {page 51}.

Displays the operating mode (USB, LSB, FM, AM, CW, CWR, FSK, or FSR) {page 11}.

Appears while in Menu mode {page 14}.

Appears while in Memory Scroll mode {page 42}.

Appears while in Memory Channel mode or Memory Scroll mode {page 42}.

In normal operating mode and various configuration modes, it displays the Memory Channel number, Quick Memory number, and entry log number. In Menu mode, it displays the Menu No.

—— C ——

Appears while in Data mode {page 38}.

Appears while in narrow FM mode {page 11}.

Appears when the receiver pre-amplifier is ON {page 40}.

Appears when the receiver’s attenuator is ON {page 40}.

—— D ——

“” appears when manual notch is set to Normal.

“” appears when Manual Notch is set to Wide.

“” appears when Auto Notch is selected {page 39}.

Appears when the Fine Tuning function is ON {page 29}.

Appears when the MHz Step function is ON {page 28}. Also appears when the Quick Menu function is ON {page 14}.

“” or “” appears, depending on whether DSP Noise Reduction 1 or Noise Reduction 2 is selected {page 39}.

“” appears when the RX Equalizer function is ON {page 55}. “” appears when the TX Equalizer function is ON {page 32}.

“” or “” appears, when you select the DSP Beat Cancel 1 or Beat Cancel 2 {page 39}.

“” appears when the Tone function is ON {page 25}, and blinks during Tone scan. “ ” appears when the CTCSS (Continuous Tone Coded Squelch System) function is ON, and blinks during CTCSS scan {page 26}. “” appears when the Cross Tone function is ON {page 27}.

7