&211(&7,1*3(5,3+(5$/(48,30(17

$17(11$781(5

Use the ANT 1 and AT connectors to connect an AT-300 external antenna tuner. If you connect the external antenna tuner to the ANT 2 connector, it will not function.

Note: The AT-300 cannot be used for 50 MHz operation.

ANT 1 connector

TS-590S

AT-300

(The AT-300 Antenna Tuner is a discontinued model. It may no longer be available in your area.)

71&$1'0&3

Use the DATA connector to connect the Audio input/ output lines from a Terminal Node Controller (TNC) for Packet operation, a Multimode Communications Processor (MCP) for operation on AFSK, Packet, PacTOR, AMTOR, G-TORTM, PSK31, or FAX, or a Clover interface. Also use the ACC 2 connector to connect SSTV and phone patch equipment.

Connect the TNC or MCP to the ACC 2 connector using a cable equipped with a 13-pin DIN plug.

Connecting the TNC or MCP to a personal computer or dumb terminal requires an RS-232C cable.

Select LSB or USB mode (it depends on the communication mode) when you operate the MCP/ TNC.

Note: Do not share a single power supply between the transceiver and the TNC or MCP. Keep as wide a separation as possible between the transceiver and the computer to reduce noise-pickup by the transceiver.

Power supply for TNC/ MCP

TNC/MCP

Personal computer

TS-590S

69

Page 77
Image 77
Kenwood TS-590S instruction manual $1711$7815, 71&$10&3