7+$1.<28
Thank you for choosing this Kenwood
This transceiver features a Digital Signal Processing (DSP) unit to process IF and AF signals. By taking maximum advantage of DSP technology, the
For example, each time you change the Menu No. in Menu mode, you will see scrolling messages on the display, telling you what you are selecting.
Though user friendly, this transceiver is technically sophisticated and some features may be new to you. Consider this manual to be a personal tutorial from the designers. Allow the manual to guide you through the learning process now, then act as a reference in the coming years.
)($785(6
•All mode operation from HF to 50 MHz amateur radio band
•500 Hz/ 2.7 kHz roofing filter
•Superior C/N response by the DDS largely decreases the noise of the undesired signal.
•IF DSP through the adoption of
DSP
•Digital Noise Blanker
•PC interface via a Universal Serial Bus port
•Drive output and RX only antenna connector
•Direct band keys
•
•100 W output power for SSB, CW, FSK, FM, and 25 W output power for AM.
127,&(727+(86(5
One or more of the following statements may be applicable for this equipment.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer for technical assistance.
%()25(67$57,1*
Amateur radio regulations vary from country to country. Confirm your local amateur radio regulations and requirements before operating the transceiver.
Depending on the size and type of vehicle, the maximum transmission output power for the mobile operation will vary. The maximum transmission output power is usually specified by the car manufacturer
to avoid interference with other electric devices used in the vehicle. Consult your car manufacturer and amateur radio equipment dealer for the requirements and installation.
0$5.(7&2'(6
E-type: Europe
The market code is shown on the carton box.
Refer to the specifications {page 81} for information on the available operating frequencies.
Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collection systems)
Products and batteries with the symbol
Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and their waste byproducts.
Contact your local authority for details in locating a recycle facility nearest to you.
Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment.
i
